zoom Posted May 20, 2005 Report Share Posted May 20, 2005 For those of you who have pinned rocker arm studs, how did you go about it? What size drill bit and what size roll pin. How deep did you drill? What are the benefits? Screw in studs are prefferable, I understand that, what is the process that is used to put screw in studs in? Thanks Link to comment Share on other sites More sharing options...
supertx Posted May 21, 2005 Report Share Posted May 21, 2005 Zoom I have used a .062 drill bit same size split pin. when you drill you go all the way threw the stud boss and stud. You can do it on a small drill press or mill if you have access. Link to comment Share on other sites More sharing options...
zoom Posted May 22, 2005 Author Report Share Posted May 22, 2005 Thanks Supertx. Do you want the length of the split roll pin to go all the way through the boss? Not sticking out but about flush? By the way, what is the cost of getting the heads machined for screw in studs? Link to comment Share on other sites More sharing options...
supertx Posted May 23, 2005 Report Share Posted May 23, 2005 put the pin in flush. man i don't know what it cost to have screw in studs done. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.