Truck99 Posted March 13, 2005 Report Share Posted March 13, 2005 We went to remove an ATI Superdamper from one motor to put on the newer one today and found the dang thing stuck. We've already stripped out one damper puller tool trying to get it off. It went on just fine last year, but now it has apparently become emotionally attached to the new motor. Any tricks out there to remove a stuck balancer? Thanks Link to comment Share on other sites More sharing options...
smallblock Posted March 13, 2005 Report Share Posted March 13, 2005 GET A CAN OF FREON TAP THE END AND FREEZE THE BALANCER THIS WILL ALLOW IT TO COME OFF DONT LET EPA SEE YA THOUGH Link to comment Share on other sites More sharing options...
supertx Posted March 13, 2005 Report Share Posted March 13, 2005 Put your puller on and apply pressure. Use a popane torch and apply heat to the back side on the collar as you slowly rotate the engine.I use an impact to rotate the engine and to apply the pressure. If you have some one to help you can tap on it also as your doing as described above. Link to comment Share on other sites More sharing options...
lbeaver087 Posted March 13, 2005 Report Share Posted March 13, 2005 put your puller back on and tighten the puller as tigh as you can get it then start tapping on the balancer with a hammer keep it tight and it will come off louis b. Link to comment Share on other sites More sharing options...
thr_spectator Posted March 13, 2005 Report Share Posted March 13, 2005 go buy a can of wd-40 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.