Raceteam25 Posted April 21, 2015 Report Share Posted April 21, 2015 How would I go about measuring my frame to see if it is bent? I have a sport mod that took a hard hit to the right side. Link to comment Share on other sites More sharing options...
NickHolt Posted April 21, 2015 Report Share Posted April 21, 2015 It would have helped a lot if someone would have taken measurements before the hit. And some chassis builders will give you the measurements they use when determining what's straight and what's not. Otherwise, it's pretty much a matter of stringing out the car. Nick Link to comment Share on other sites More sharing options...
HiTech Posted April 21, 2015 Report Share Posted April 21, 2015 FIND two spots one on each side of the front lower frame cross member or something and run a tape to the center of the rear axle tubes .may give you an idea of where it is . Link to comment Share on other sites More sharing options...
sam71 Posted April 21, 2015 Report Share Posted April 21, 2015 We repair chassis here in corpus pm me Link to comment Share on other sites More sharing options...
Racer26 Posted April 21, 2015 Report Share Posted April 21, 2015 Go to the IMCA website under rules and you will find the frame diagram. Link to comment Share on other sites More sharing options...
Truck99 Posted April 21, 2015 Report Share Posted April 21, 2015 This resource might help: http://www.thedirtforum.com/Metricframe.jpg Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.